Monodisperse Dry Granular Flows on Inclined Planes : Role of Roughness

Recent studies have pointed out the importance of the basal friction on the dynamics of granular flows. We present experimental results on the influence of the roughness of the inclined plane on the dynamics of a monodisperse dry granular flow. We found experimentally that it exists a maximum of the friction for a given relative roughness. This maximum is shown to be independent of the angle of the slope. This behavior is observed for four planes with different bump sizes (given by the size of the beads glued on the plane) from 200 microns to 2 mm. The relative roughness corresponding to the maximum of the friction can be predicted with a geometrical model of stability of one single bead on the plane. The main parameters are the size of the bumps and the size of the flowing beads. In order to obtain a higher precision, the model also takes into account of the spacing between the bumps of the rough plane. Experimental results and model are in good agreement for all the planes we studied. Other parameters, like the sphericity of the beads, or irregularities in the thickness of the layer of glued particles, are shown to be of influence on the friction.Comment: 17 pages, 15 figures, submitted to EPJ

Bidisperse granular avalanches on inclined planes: A rich variety of behaviors

Experiments were performed to provide insight into the flow behavior and structure of bimodal mixtures of grains in gravity-driven, free-surface flows. Unsteady unconfined flows were produced by releasing instantaneously a dry granular mass, composed of two particle sizes, over a rough inclined plane. As a result of size segregation, the small particles are found at the bottom of the flow and final deposit, the large particles are found at the free surface, but also on the lateral borders and at the front of the flow. The lateral and vertical inhomogeneous repartitions of particles lead to two main effects that are completely absent in monodispersed flows. The outline effect results from the accumulation of large beads on the periphery of the flow depending on the value of the relative friction of each particle species on the plane. This effect in turn causes a narrowing of the flow and/or an increase of length of the final deposit. The interface effect results of the interaction between layers of different size particles and causes the modification of the thickness of the deposit. These effects occur simultaneously and their combination leads to a great variety of behaviors. In this investigation, evidence of the diversity of behaviors is presented as the size ratio, relative friction and concentration of each particle species are varied

Discharge flow of a bidisperse granular media from a silo

International audienceThe discharge flow in a cylindrical and a rectangular silo using both monodisperse and bidisperse mixtures of spherical glass beads is studied experimentally. The flow rate is measured using a precision balance for a large range of particle diameters, size ratios, and outlet diameters. A simple physical model is proposed to describe the flow of bidisperse mixtures. It gives an expression for the flow rate and predicts that the bulk velocity follows a simple mixture law. This model implies that a mixture diameter cannot be simply defined. Moreover it is shown that bidisperse granular media allow for the transport of coarse particles below their jamming conditions

Assessing the homogeneity of powder mixtures by on-line electrical capacitance

4th International Conference on Conveying and Handling of Particulate Solids, Budapest, HUNGARY, MAY 27-30, 2003International audienceIn this paper, we try to improve our comprehension of one of the most important challenge in the particulate solids industry: the assessment of the homogeneity of powder mixtures. A two-electrode electrical capacitance method is used to measure the permittivity of mixtures while flowing in a 1-D set up. An emphasis is placed on the possibility of following homogeneity evolution through permittivity measurement, without the necessity to calculate the volumetric proportions of each component from an effective medium formulation. The methodology is applied to examine segregation in a funnel, as well as the efficiency of a laboratory drum mixer